Infinite Control Switch
This infinite control switch used with most manual kilns cycles "On" and "Off" through a bi-metallic timer.
The higher the setting the longer the heating elements stay on, and the faster the kiln ramps to its final
temperature.  At the highest setting the kiln elements stay on for the most rapid heating rate.  These switches
are priced in the kiln cost where shown.

PCB-1 Infinite Switch
This infinite switch is portable and works with any kiln rated to 120 volts, 15 amps.  It is ideal to add
to the QuikFire 6 kiln for better control.

Price $66.00

Sentry Xpress 3-Key for Glass Fusing 
 On glass and jewelry kilns, it includes Single Segment and 8 segment Ramp-Hold modes. 
The Skip segment skips past a segment during Ramp-Hold firing.  The Hold segment maintains the temperature. The storage memory for Ramp-Hold mode can store 4 programs.  Program Review lets you check that the program you are about to fire is correct.  Temperature Display throughout firing and cooling in your choice of °F or °C . Error Messages report mechanical problems such as a disconnected thermocouple, stuck relay or broken element. 
There is a 12 Month Warranty.  LED Lights show whether you are in program, review, or firing mode. 
It has Quick Release Molex Connectors. 

• 14 segment display messages are easier to read than 7 segment types
• Storage for 20-segments and three 10-segment user programs in Ramp/Hold
• The Add Time key adds five minutes needed to perfect a project without reprogramming the controller.
• Better temperature stability
• A cool down segment available in cone fire programs at every speed.
• Alter the Standard Slow, Medium and Fast firing speeds with the Options key.
• Selection between types K, S and R thermocouples with a simple keystroke.
• A program safety lock to prevent changing program in active mode.
• Correct programming errors with the Stop/Back key.
• Greater resistance to RF radiation.
• Multiple zone firing is faster and more accurate than before.
• Quick release Molex connectors allow fast removal of controller without tools.
• Pre-Heat allows you to dry out the kiln at 200 degrees for the period you specify.

    Purchase controller board only  $350  (specify 1700 deg, 2000 deg, 2400 deg. to match kiln)