Home My Account Shopping Cart (0)
Menu

> OLYMPIC KILNS > OLYMPIC CONTROLLERS

 

You can add a 12 key controller for $50 more, but you must call the order in.

Electro Sitter will replace your obsolete kiln sitter model! The Electro Sitter comes complete with electronic controller of your choice for cone-fire or ramp/hold programming, an attached Type K thermocouple, ceramic fiber, and electronic controller manual.  

 

Installation is easy. The Electro Sitter will fit where the kiln sitter/timer is attached to the kiln. Simply remove the screws from the kiln sitter on the front of the kiln, then detach wires connecting to the kiln sitter. Wires will be attached to the back of the Electro Sitter exactly as they were attached to the kiln sitter terminal block.  The thermocouple from the Electro Sitter goes through the kiln sitter hole and is exposed 1" inside the kiln.  Use fiber to fill space in kiln sitter hole. After the Electro Sitter is installed, read the controller manual that came with it.  When you are ready to programmed the controller, turn kiln switches to high. Your now have an electronically controlled kiln!

 

Electro Sitters may be used in any brand kiln that has a kiln sitter.  The units are rated up to 50 amps, higher amperages available at an additional charge. 

 

Controller selections - 3 Key - 4 user programs for ramp-hold programming, 3K-CF - 4 user programs for ramp-hold programming and cone-fire firing schedules

 

V6-CF - 12 key digital controller with 6 user programs for ramp-hold programming and cone-fire firing schedules, RTC-1000 - 12 key digital controller with 6 user programs for ramp-hold programming 


 

For more detailed information about the controller choices call us.

This category doesn't have anything in it, but check back soon
UA-68984994-1